Low

PANASONIC ELECTRONIC COMPONENTS  ENW-89841A3KF  BLUETOOTH 2.1 + EDR MODULE 2.402GHZ TO 2.48GHZ

PANASONIC ELECTRONIC COMPONENTS ENW-89841A3KF
Technical Data Sheet (343.07KB) EN Technical Data Sheet (2.94MB) EN Ver todos los documentos técnicos

La imagen solo tiene fines ilustrativos. Consulte la descripción del producto.

Resumen del producto

The ENW-89841A3KF is a Wireless UART Interface Module used for communication between the host and PAN1322-SPP. The lines UARTTXD and UARTRXD are used for commands, events and data. The lines UARTRTS and UARTCTS are used for hardware flow control. Low power mode control of PAN1322-SPP and the host can be implemented in by using the pins P0.14 and P0.0. P0.14 is used by the host to allow PAN1322-SPP to enter low power mode and P0.0 is used by PAN1322-SPP to wake-up the host when attention is required. Additionally, the host could hardware reset PAN1322-SPP using the RESET pins. Power is supplied to a single VSUPPLY input from which internal regulators can generate all required voltages. The UART and the GPIO's interfaces have separate supply voltages so that they can comply with host signalling.
  • Implements a single point-to-point data link to other SPP capable Bluetooth devices
  • Ultra low power design in 0.13μm CMOS
  • On-module voltage regulators
  • On-module EEPROM with configuration data
  • On-module tuned reference clock
  • Module can enter low power mode in idle state and during sniff intervals
  • AT command interface over UART with HW flows control
  • Default UART baud rate 115200bps
  • Module configuration reprogrammable for 9600-bit/s up to 3.25Mbps UART baud rate
  • JTAG for boundary scan in production test
  • -86dBm Typical receiver sensitivity
  • Secure simple pairing
  • Single point-to-point data link, role switch supported
  • Packet data mode and stream data mode supported
  • Sniff mode and sniff sub-rating is supported with above capabilities
  • 5 Trusted devices stored in EEPROM

Información del producto

Tensión de Alimentación Mín.:
2.9V
Tensión de Alimentación Máx.:
3.6V
Rango de Señal Máx.:
-
Rango de Datos:
3Mbps
Versión de Bluetooth:
Bluetooth 2.1 + EDR
Clase de Bluetooth:
Clase 2
Sensibilidad de Recepción:
-86dBm
Temperatura de Trabajo Mín.:
-40°C
Temperatura de Trabajo Máx.:
85°C
Rango de Producto:
-
Interfaces Físicas:
UART
Sustancia Extremadamente Preocupante (SVHC):
To Be Advised
Intervalo de Frecuencia de Funcionamiento:
2.402GHz to 2.48GHz

Encontrar productos similares  agrupados por atributos en común

Aplicaciones

  • Inalámbrico;
  • Comunicaciones y Red

Legislación y medioambiente

Conforme a RoHS:
Distribuidor autorizado

Productos similares