AD5930YRUZ

AD5930 is a waveform generator with programmable frequency sweep and output burst capability. Utilizing embedded digital processing that allows enhanced frequency control, the device generates synthesized analog or digital frequency-stepped waveforms. Because frequency profiles are pre-programmed, continuous write cycles are eliminated and thereby free up valuable DSP/microcontroller resources. Waveforms start from a known phase and are incremented phase continuously, which allows phase shifts to be easily determined. Consuming only 8mA, this device provides a convenient low power solution to waveform generation. It is used in applications such as frequency sweeping/radar, network/impedance measurements, incremental frequency stimulus, sensory applications, proximity and motion, BFSK, frequency bursting/pulse trains.

• Programmable frequency profile, no external components necessary
• Output frequency upto 25MHz, burst and listen capability
• Preprogrammable frequency profile minimizes number of DSP/microcontroller writes
• Sinusoidal/triangular/square wave outputs, automatic or single pin control of frequency stepping
• Waveform starts at known phase, increments at 0° phase or phase continuously
• Power supply range from 2.3V to 5.5V, output rise/fall time is 12ns typical
• Resolution is 10bits, update rate is 50MSPS maximum at (AVDD = DVDD = 2.3V to 5.5V)
• Signal-to-noise ratio is 60dB typical at (fMCLK = 50MHz, fOUT = fMCLK/4096)
• Low power sleep mode is 20µA typical at (AVDD = DVDD = 2.3V to 5.5V)
• Operating temperature range from -40°C to +125°C, package style is 20-lead TSSOP

Notas

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party