LT6300CGN#PBF

LT6300CGN#PBF is a 500mA minimum output current, dual opamp with outstanding distortion performance. The amplifiers are gain-of-ten stable, but can be easily compensated for lower gains. The extended output swing allows for lower supply rails to reduce system power. Supply current is set with an external resistor to optimize power dissipation. It features balanced, high impedance inputs with low input bias current and input offset voltage. Active termination is easily implemented for further system power reduction. Short-circuit protection and thermal shutdown insure the device’s ruggedness. It is used in applications such as high efficiency ADSL, HDSL2, SHDSL line drivers, buffers, test equipment amplifiers, cable drivers.

• Exceeds all requirements for full rate, downstream ADSL line drivers
• Power saving adjustable supply current, specified at ±12V and ±5V
• Input offset voltage is 1mV typical at (TA = 25°C, VCM = 0V)
• Input offset voltage drift is 10µV/°C typical at (TA = 25°C, VCM = 0V)
• Input bias current is ±0.1µA typical at (TA = 25°C, VCM = 0V)
• Input noise voltage density is 8nV/√Hz typical at ( f = 10KHz, TA = 25°C, VCM = 0V)
• Common mode rejection ratio is 83dB typical at (TA = 25°C, VCM = 0V)
• Supply current per amplifier is 10mA typical at (VS = ±12V, RBIAS = 24.9K)
• Gain bandwidth is 200MHz typical at (f = 1MHz, TA = 25°C, VCM = 0V)
• Operating temperature range from -40°C to 85°C, 16-lead plastic SSOP package

Notas

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party